Line 3: invalid/unknown driver 'rt1871xdrv'Ģ errors found in configuration file '/etc/hostapd/nf'įailed to set up interface with /etc/hostapd/hostapd. Line 1: invalid line '$ cat /etc/hostapd/nf' This is /etc/hostapd/nf: interface=wlan1Īnd then this: bigbird:~/rt8192cu $ sudo hostapd -B /etc/hostapd/nfĬonfiguration file: /etc/hostapd/nf This is what was returned: Bus 001 Device 002: ID 0bda:8178 Realtek Semiconductor Corp. I ran lsusb to see what driver I should be using in case that was part of the issue. Link Quality:0 Signal level:0 Noise level:0 Mode:Auto Frequency=2.412 GHz Access Point: Not-Associated This tutorial will guide you through the new method to setup your Raspberry Pi Zero WH from start to finish. Tx excessive retries:0 Invalid misc:0 Missed beacon:0 85K views 1 year ago Raspberry Pi Tutorials. Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Retry short limit:7 RTS thr:off Fragment thr:off I know that I’ve got to be missing some detail somewhere but I’m not sure what steps to take first to troubleshoot this problem.Īfter following the tutorial listed in the comments this is returned from iwconfig: wlan0 IEEE 802.11 ESSID:"Zimm_Wrls" When I finished and rebooted the USB adapter connected to the same Wi-Fi network that the internal Wi-Fi connects to.
The USB adapter will host the access point and will connect to a controller through a very directional antenna. The built in wifi will connect to my wifi at home to run updates browse logs and the like. The pi that I’m working on will be an on board computer for a drone. I do have an additional USB adapter connected. I followed the tutorial, Raspberry Pi Wireless Access Point, to set my Raspberry Pi Zero as an access point.
0 kommentar(er)
